3-3. Adjusting the height of the knee lifter
WARNING :
To protect against possible personal injury due to abrupt start of the machine, be sure to start the
following work after turning the power off and ascertaining that the motor is at rest.
1
) The standard heght of the presser foot lfted usng the knee lfter s 2 mm.
2) You can adjust the presser foot lft up to 3 mm usng knee lfter adjust screw 1 .
Do not operate the sewing machine in the state that the presser foot 3 is lifted by 12 mm or
more since the needle bar 2 comes in contact with the presser foot 3 .
3-4. Installation of thread stand
2
1
Assemble the thread stand, set t up on the machne
table usng the nstallaton hole n the table and
tghten nut 1 gently.
When you use power suppled by the overhead
power lne, pass the power supply cord through hol-
low spool rest rod 2 .
– 6� –
2
3