6-6. Adjusting the height and the inclination of the feed dog
WARNING :
To protect against possible personal injury due to abrupt start of the machine, be sure to start the
following work after turning the power off and ascertaining that the motor is at rest.
1mm
2
3
A
B
3
1
4
5
C
– 38 –
(1) Adjusting the height
) Loosen feed drvng lnk setscrew 1 . Turn feed
drvng lnk shaft 2 to adjust the heght of the
feed dog. Standard heght s mm from the
throat plate n the hghest poston.
(2) Inclination
) Remove cap 4 on the sde of machne bed,
loosen feed bar shaft setscrew 3 , and turn
knurled secton 5 to adjust the nclnaton.
Standard nclnaton s the poston where en-
graved marker dot A of feed bar arm algns wth
engraved marker dot B of feed bar shaft. (En-
graved marker dot C s not used.)