JUKI LH-3500A series Instruction Manual page 17

6
3
7
4
1
Table
1B
8
9
!0
4
5
6
Away from the
operator side
2
1B
1A
Operator side
4
5
6
– 5 –
2) Fx rubber cushon 6 on control-box mountng plate
3 wth nut 4 and sprng washer 7 . Three sets of
2 are requred.
3) Fx control-box mountng plates 2 assembled
n step 2) on the table wth decoraton bolts 1 ,
washers 8 , sprng washers 9 and nuts !0 .
Screw 1A at one locaton ths sde as observed
from the operator should be securely tghtened,
and two screws 1B at two locatons far sde
from the operator should be temporarly tght-
ened.
* Install control-box mountng plate 3 as llustrat-
ed in the figure, carefully checking the installing
drecton and the locaton of holes.
* The washers, sprng washers and nuts suppled
wth the SC-920 should be used.
4) Place the SC-920 on rubber cushons 6 and fix
wth nuts 4 and washers 5 .
Install the control box whle carefully changng the
position of the temporarily-fixed control-box mounting
plate (rght one as observed from the worker).
1. If you use the decoration bolt supplied
with the SC-920, the control box cannot
be installed since the bolt interferes with
the control box.
2. If the control-box mounting plates are
fixed on the table in a wrong installing
direction or with the hole located at a
wrong position, the control box cannot
be installed.
4
5
6
Away from the
operator side