Setting Up The Sc-920 - JUKI LH-3500A series Instruction Manual

2
1
After completon of the operaton, turn the power OFF and re-turn t
ON to restore the normal operaton.
(3) Releasing procedure of the grease-up "error" For SC-920
When usng the machne for a certan perod of tme after the dsplay of error No. 220 (contnung usng the
machne wthout performng grease-up at the tme of dsplayng No. 220), error No. 22 s dsplayed and the
machne stops runnng.
In this case, apply grease to the specified sections, then reset the error according to the description given in
"(2) Releasing procedure of the grease-up warning for SC-920" p.
After completon of the operaton, turn the power OFF and re-turn t ON to restore the normal operaton.

4-7. Setting up the SC-920

(1) Specifications
Supply voltage 3-phase 200 to 240V
Frequency 50Hz/6�0Hz
Operatng env- Temperature : 0 to 40˚C
ronment Humdty : 90% or less
Input 320VA
(2) Installing on the table (LH-3528A-7, 3568A-7, 3578A-7 and 3588A-7)
Parts supplied with SC-920
×
1
8
9
!0
Table
6
3 4
Parts supplied with LH-3500A
6
3
7
4
1
Operator side
5) When settng No. 6 s adjusted
5
6�) When the change has been com-
13.
) Hammer decoraton bolt Hammer decoraton bolt 1 suppled wth the LH-
3500A nto table.
The decoration bolt supplied with the
SC-920 is not used.
– 4 –
to "8", the current set value s
dsplayed on LE� 5 . Then Press
swtch 4 (swtch
change to "".
pleted, press swtch
1 to specfy the changed value.
When turning OFF the
power before performing
this work, the contents
which have been changed
are not updated.
3 ) to
2 or