Deleting Community Strings; Ending The Session; Rebooting The Unit - IMC Networks IE-MiniFiberLinX-II Operation Manual

Steps:
1. Type C on the main configuration screen.
2. Enter the name of the new community (up to 16 characters, no spaces) and press
Enter.
3. Type one of the following to assign the community string's access rights:
•
R = read-only access
•
W = read/write access
•
Enter = abort
4. After entering R or W, press Enter.
5. To finish, press Enter, and reboot.

Deleting Community Strings

To delete all community strings, perform the following:
1. Press U. The "Are you sure you want to delete all future strings?" prompt
displays.
2. Press Y to proceed, N to abort.
3. Press Enter.
This function will delete ALL community strings. To selectively delete community
strings, use iConfig to configure the device.

Ending the Session

Be sure to press E to end a serial port or Telnet/Hyperterminal session, before
disconnecting the cable. This will stop the continuous stream of data to the serial
port.

Rebooting the Unit

To reboot the IE-MiniFiberLinX-II, type reboot.
Enabling/Disabling DHCP
To toggle DHCP on the IE-MiniFiberLinX-II between enable and disable, press D.
19