Setting The Mid-Stop - Genie GCL-MT Installation Manual

Setting the Mid-Stop

The operator includes a programmable Mid-Stop. This feature
allows the operator stop at a user selectable point when opening. It is
used when operating very tall doors that only open to their full height
occasionally. The Mid-Stop does not effect the operator when closing.
1) To operate door to full open position from mid-stop, press open
button again.
NOTE: Setting of the MID-STOP should only be performed AFTER Travel
Limit and Max Run Timer settings have been made.
To set the Mid-Stop:
1) Press CAL/RUN to enter calibration mode.
2) Press the CLOSE key to close the door to the down limit.
) until the display reads "MID-STOP > CLEAR."
3) Press SCROLL (
Fig. 11.
NOTE: If the display reads MID-STOP > SET at this point, first clear the
MID-STOP as described below then repeat steps 1-3 and continue.
4) Press the OPEN key to open the door and release the key
when the door is at the desired Mid-Stop height.
5) Press the SET/CLEAR until the display reads "MID-STOP > SET."
6) Press CAL/RUN to return to run mode.
To clear the Mid-Stop:
1) Press CAL/RUN to enter calibration mode.
) until the display reads MID-STOP > SET.
2) Press SCROLL (
3) Press SET/CLEAR until the display reads MID-STOP > CLR
4) Press CAL/RUN to return to run mode.
GCL-MT
Medium Duty Operator
www.geniecompany.com
MID-STOP CLR
Figure 11
08-12
6.7