Table of Contents
Advertisement
SPECIFICATIONS
Oven Interior Dimensions
Height
Width
13-12
26-1/4"
(343mm)
(667mm)
Hot Top
Griddle
BTU
kW
BTU
25,000
7.32
50,000
NOTE: Installation clearance reductions are applicable only where local codes permit.
Garland/U.S. Range products are not approved or authorized for home or residential use, but are intended for commercial
applications only. Garland / U.S. Range will not provide service, warranty, maintenance or support of any kind other than in
commercial applications..
Commercial cooking equipment requires an adequate ventilation system. For additional information, refer to the National Fire
Protection Association's standard NFPA96..
INTRODUCTION
This equipment must be installed and adjusted by a
competent person in accordance with the law. Failure to
install appliances correctly could lead to prosecution. It is
in your own interests and that of safety to ensure that the
law is complied with. Your Garland Dealer is well qualified to
provide this service.
This appliance should be given regular care and
maintenance. Periodic inspections by the dealer or a
qualified service company are recommended to check
temperature, burner adjustments and to ensure moving
parts are operative. Wherever possible avoid overheating idle
equipment as this is the primary cause of increased service
cost.
"Regular maintenance ensures peak performance . "
Unpacking:
1. Check crate for possible damage sustained during transit.
Carefully remove unit from crate and again check for
damage. Any damage to the appliance must be reported
to the carrier immediately.
Part # 4517957 Rev.13 (02/10/11)
Entry Clearance
Depth
Crated
22"
43"
(559mm)
(1105mm)
* Distance from combustible construction
Input Ratings
Oven
kW
BTU
kW
14.65
38,000
11.14
113,000
Installation
Clearances*
Uncrated
Sides
37-7/8"
7"
(648mm)
(178mm)
Operating Pressure
Total
Natural
BTU
KW
"WC
33.11
4.5
2. The wires for retaining the burners and other packing
material must be removed from units. Any protective
material covering stainless steel parts must also be
removed.
3. All ranges are shipped from the factory with casters fitted.
4. The type of gas and the supply pressure that the
equipment was set up for at the factory is noted on the
data plate and on the packaging. This type of gas supply
must be used.
5. Do not remove permanently affixed labels, warnings or
data plates from the appliance, for this may invalidate the
manufacturer's warranty.
NOTE: Many parts of the equipment are raw steel i.e griddle
top and solid hot top and can react with moisture forming
rust. This is normal and not considered a defect. Clean with a
stainless steel fiber pad. A light coating of salt free oil may be
applied to prevent further rusting.
Shipping
Weight
Rear
6"
584lbs
(152mm)
(265kg)
Total Maximum
Propane
mbar
"WC
mbar
120V
11
10
25
4.5 Amps 2.3 Amps
Manifold
Inlet Size
3/4" NPT
Female
Electrical Load
230V
Page 5
Advertisement
Table of Contents
