Chapter 6. General Operations; System Operations; General Care And Maintenance; Power On And Off Sequence - Fujitsu TeamPoS 3600 Series Installation & Maintenance Manual

PoS
Team 3600 Series

Chapter 6. General Operations

6.1

System Operations

This section contains general and periodic care and maintenance, and power ON and OFF
procedures for the

6.1.1 General Care and Maintenance

General cleaning of the terminal is required on a regular basis. In particular, dust must be
removed from external components, air vents, fans, and exhaust screens to allow sufficient
airflow to maintain proper internal operating temperatures. The frequency of this cleaning
depends on installed environments. Lack of this cleaning will greatly reduce equipment
reliability.
To keep the terminal and its peripherals in good working condition, follow the guidelines in
this section.
1. Wipe the terminal with a clean, soft cloth, dampened with water and mild soap.
Never use abrasive pads or cleansers.
2. Make sure all cable connectors are securely installed on the terminal and
peripherals to prevent the cables from being accidentally disconnected.
Disconnecting and connecting cables (except USB cables) while the power is on
could cause damage to the terminal and its peripherals.
3.
Do not expose the terminal to liquids. Although the units are designed to resist
liquids from entering the internal components, liquids should be kept away from the
terminal.

6.1.2 Power ON and OFF Sequence

This section presents the general procedures for powering the
controller ON and OFF. The instructions in this section assume that the terminal, operating
system, and the application software have been installed. For any additional power on and
off procedures dictated by the retail application, refer to the manuals provided with your
PoS and application software.
Caution: With the exception of USB peripherals, never remove or
D900000338
Team PoS 3600 Series
connect any peripheral while power is on its port. To avoid
damage to the controller and peripherals, when connecting and
disconnecting RS232 peripherals from the I/O Boards, turn off the
controller by depressing the
switch (in the front of the unit) or by disconnecting AC power.
Issue 3
terminal.
Team
PoS
Team 3600 Series
General Operations
PoS
3600 Series
power
6-1