Installing The Hard Disk Drives - Fujitsu TeamPoS 3600 Series Installation & Maintenance Manual

PoS
Team 3600 Series
5.3

Installing the Hard Disk Drives

Caution: Be sure to observe all ESD precautions and power off procedures.
Caution: Hard disk drives come pre-installed and tested in their tray from the
factory. Replacing the disk drive with other manufacturer disk drives is not
supported by Fujitsu. It is highly recommended that only trained service
personnel replace the hard disk drives.
1. Open the front panel.(See Section 5.1)
2. Remove the disk drive filler plate from the controller chassis.
3. Attach hard disk drive to hard drive bracket by pulling on the release band on both sides in
order for the drive to fit and secure itself in the hard drive bracket. When the released band is
pulled, the pins that hold the drive in place will retract in order for the drive to slide into
place.
D900000338 Issue 3
Installation
Release
band
5-6