Fujitsu TeamPoS 3600 Series Installation & Maintenance Manual page 26

PoS
Team 3600 Series
To the User:
•
DO read the operating instructions carefully before you attempt to use this
equipment.
•
DO ensure that the supply connector or isolator is readily accessible to enable
isolation of the equipment
•
DO ensure that a competently trained person checks that all electrical connections
(including the supply plug and any extension leads) are properly made in
accordance with the instructions.
•
DO NOT allow the supply cord to be positioned where it may be snagged, crushed
or stretched across a sharp edge.
•
DO NOT continue to operate the equipment if you have ANY doubt about it
working normally, or if it is damaged in any way. Instead, switch it off and, if the
equipment is pluggable, remove the supply cord and contact your local service
agent.
•
DO NOT remove any fixed covers unless you are qualified / authorized to do so for
the preparation of the equipment. There are no user serviceable parts under the
covers unless expressly indicated in the equipment governing manual. Always
remove the power plug from the power source before removing any covers, and
ensure ALL covers are replaced and correctly secured before re-connecting the
power plug.
•
DO NOT obstruct any of the ventilation slots in the equipment. Obstruction of
these slots can cause overheating, reduce equipment reliability and shorten the life
of the equipment.
•
DO NOT expose the equipment to spilled liquids
•
DO NOT replace the power cable with a different type than is called up in the
instruction documentation or supplied with the equipment.
Note : For model 3600 Series equipment the following warning applies:
The 24V powered USB port on the terminal does not meet UL/CSA limited power source
(LPS) requirements. This port is limited to only allowing 24V Retail POS powered USB
peripherals that do not exceed a rated current of 4 Amps and are provided with a molded
plastic fire enclosure, rated min. 94V-1 or Metal enclosure. Peripherals intended to be
connected via - jacketed cable for external use and marked VW-1 or FT-1.
If installed, the RJ25 connector (cash drawer port) on the powered USB PWB does not
meet UL limited power source (LPS) requirements. This connector is limited to only
allowing products that have an enclosure made of metal or made of material with a
minimum flammability rating of 94V-1.
For more information or to download the latest manuals for your Fujitsu point of sales(s)
equipment, please go to the Fujitsu website:
D900000338
http://www.fujitsu.com/us/services/retailing/
Issue 3
Site Preparation
4-6