Self Cleaning Burner System (Not On All Models) - Pitco SG6H Installation & Operation Manual

MODEL SG6H FRYER

4.4. SELF CLEANING BURNER SYSTEM (NOT ON ALL MODELS)

If your appliance is equipped with the self cleaning burner system, the appliance should behave as
outlined in the table below. A cleaning cycle will execute every time the appliance is turned "ON" from
an "OFF" state. The thermal cut out switch is designed to disable the appliance if the Self Cleaning
Burner System malfunctions and remains activated for an extended period of time or if there is a
downdraft into the flue or a blocked flue situation.
Event
Turn appliance "ON"
Pre-Purge Pulse
Interwaiting period 1
Cleaning Pulse
Interwaiting period 2
Normal operation
resumes
Duration Indication
Control Illuminates, pilot sparks and ignites. Pre-Purge
N/A
pulse is initiated.
2 seconds Appliance operates briefly and stops. Pilot remains lit.
5 seconds Appliance does not operate. Pilot remains lit.
Main valve operates, lighting main burners. SCBS valve
operates, feeding gas to the SCBS Arm. The SCBS arm
6 seconds
ignites, initiating a brief burn at the main burner orifice of
each burner.
The Main and SCBS valves de-energize for this period.
8 seconds
The pilot remains lit.
The appliance operates normally and begins to heat up.
The SCBS Valve remains de-energized until power to
N/A
the appliance is recycled. There is no flame on the
SCBS Arm. There is no burn at the main burner orifices.
L20-332, rev. 1 (05/11)
TROUBLESHOOTING
25