Installation Clearances; Leg/Caster Installation And Leveling - Pitco SG6H Installation & Operation Manual

MODEL SG6H FRYER

1.2. INSTALLATION CLEARANCES

The clearances shown below are for combustible and non-combustible installations and will allow for
safe and proper operation of your appliance.
Back
Sides
Floor
In addition to the above clearances there must also be at least 16 inches (40.64cm) of aisle space in
front of the unit.
DO NOT obstruct the flow of ventilation, or air openings
around the appliance. Adequate clearance around the
appliance is necessary for servicing and proper
component ventilation. Ensure that you meet the
minimum clearance requirements specified in this manual.
To prevent equipment damage and/or personal injury, do not tilt the appliance onto any
two of its casters or legs, or pull the appliance by the splash back.

1.3. LEG/CASTER INSTALLATION AND LEVELING

When you receive your appliance it is completely assembled with the possible exception of the legs
(or casters). This appliance must be installed with legs or casters; it cannot be curb mounted. Curb
mounting will seriously inhibit this appliance's ability to effect proper component ventilation. The
legs/casters must be installed before connecting the appliance to the power supply. The legs/casters
provide the necessary height to meet sanitation requirements and assure adequate air supply to the
combustion system. Use the following procedure.
This appliance must be installed with the legs or casters provided by the manufacturer.
Required tools: 7/16 " wrench and socket and a large pair of water pump pliers.
1. Lay the appliance on its back, being careful not to
damage the splash back by pulling on it. Protect the
outside of the appliance with cardboard or a drop
cloth when laying it down.
2. Attach each leg/caster with the hex head screws and
nuts supplied. Each leg/caster requires four ¼-20 x
5/8" hex head screws and nuts. Insure that all
screws are tight.
3. Mount the screws from the inside of the appliance
with the nut on the outside (bottom) of the
appliance. The nuts have lock washers attached
to them, therefore it is not necessary to use
separate lock washers.
4. When all four legs/casters are securely mounted, stand the unit up, being careful not to put too
much weight on any one leg. Adjust the height and level the appliance by adjusting the leveling
devices (B) with water pump pliers. On casters, loosen 2 screws (A) before leveling, make your
height adjustments, then retighten.
Combustible Construction
Inches (centimeters)
6.0" (15.24cm)
6.0" (15.24cm)
6.0" (15.24cm)
WARNING
CAUTION
WARNING
L20-332, rev. 1 (05/11)
INSTALLATION
Non Combustible Construction
Inches (centimeters)
0.0" (0.0cm)
0.0" (0.0cm)
6.0" (15.24cm)
WARNING
DO NOT install this appliance next
to a water cooker. A splash over of
water into the hot oil may cause a
flash fire.
WARNING
DO NOT install legs or casters, or
perform leveling procedure when
appliance is in operation or full of hot
liquids. Serious injury could result.
3