Computer & Digital Controller Displays (If Equipped) - Pitco SG6H Installation & Operation Manual

MODEL SG6H FRYER
4.6. COMPUTER & DIGITAL CONTROLLER DISPLAYS (IF EQUIPPED)
If your appliance is equipped with a computer or digital controller it may display the following
messages on its display.
Display Explanation
Appliance is in melt cycle
Oil/shortening temperature is
low.
The cook tank has reached the
set temperature.
Indicates program mode is
password protected.
Incorrect probe reading.
Oil/shortening has reached an
unsafe temperature.
Incorrect probe reading.
Drain valve is open while
controller is on.
Ignition system has locked out. Contact Authorized Service Company.
Controller is OFF.
Action
Continue with melt cycle or exit melt cycle to
return to normal operation.
Wait for appliance to heat up.
Appliance is ready to start cook cycle.
Enter password or wait for controller to exit
program mode.
Contact Authorized Service Company.
Turn off appliance. Allow ample time for
appliance to cool before turning on.
Contact Authorized Service Company.
Turn off appliance. Close drain valve before
turning appliance back on.
Turn controller on.
L20-332, rev. 1 (05/11)
TROUBLESHOOTING
27