Pilot Removal; Burner Removal - Pitco MGII Service Manual

https://appliancetechmanuals.com
MGII and MG2T GAS FRYER
WARNING! SHUT OFF APPLIANCE AND DISCONNECT ALL POWER
WARNING! DISCONNECT APPLIANCE FROM GAS SUPPLY OR SHUT

5.3.3. Pilot Removal

1. Remove screw securing ground wire to pilot
bracket using 5/16" socket.
2. Unplug high voltage spark cable from pilot
assembly.
3. Remove 2 screws securing pilot assembly to
burner bracket using 5/16" hex bit
4. Loosen and remove pilot tubing from gas valve
using 7/16" open-end wrench.
CONNECTIONS PRIOR TO STARTING ANY SERVICE WORK
MANUAL GAS VALVE PRIOR TO SERVICING GAS TRAIN
L22-236 Rev. 2 (06/11)

5.3.4. Burner Removal

1. Close Manual Gas Shutoff Valve. (See Section
4.3.1.)
2. Loosen and disconnect top valve flare fitting
from burner manifold using 1-1/16" open end
wrench on female brass flare fitting at top of
valve and 15/16" open end wrench on male
brass flare fitting attached to burner manifold.
3. Pull gas valve assembly forward and down to
provide access to burner mounting screws.
4. On Full Tank fryers, remove screw securing
flame carryover brackets using a 5/16" hex bit.
SERVICE
23