Initial Setup; Selecting The Menulanguage; Programming Channels Into The Tv's Channel Memory; Programming Channelsautomatically - Toshiba 24SLV411U Owner's Manual

initial Setup
When you first turn on or reset the TV, the [nitial
Setup window will appear.
1 [n the Menu
Language
field, wess 4 or _ to
select your preferred language.
2 Press A or V to select Time Zone Setup and set
your desired time zone with 4 or ll_ and press o@.
3 Next, the
Location
setting window will appear.
For normal home use, press 4 or II_ to select
Home
and press @.
4 Next,
ANT/CABLE In
setup window will appear.
Press "9 or _ to select the input source
(CaNe
or
Antenna)
for the
ANT/CABLE
i nput on the TV and
press o@.
5 [f you select
Antenna,
the
Channel Tuning Node
setup window will appear. To tune only digital
channels, select Digital To tune digital channels
preferentially over analog when entering channel
number directly, select Ant0. For normal tuning,
select Standard.
Press @ to continue to Auto
Tuning.
6 Press o@ to select
StartScan
and continue with
the Auto Tuning.
You can stop the Initial Setup with %ca. However
if you do not finish the entire Initial Setup process
by pressing "_" until step 5 above, the Initial Setup
window will appear every time you turn on the TV.
Selecting the menulanguage
You can choose from three different languages
(English, French and Spanish) for the on-screen
display of menus and messages.
To select the menu language:
SETUP
Press @ and open the
Preferences
menu,
highlight
MenuLanguage.
Press "9 or II_ to select your preferred menu
language.
C.,t_CB_
3 Press @ to close the Preferences menu.
26
Configuring the antenna input
source for the ANT/CABLE terminal
To configure the ANT/CABLE input source:
SETUP
I Press @ and open
the Setup
menu.
Highlight
]nsta]]ati0n
and press @.
3 A new set of Installation menu icons will appear,
as shown below. Open the
Terrestrial
menu,
highlight Inpnt Configuration, and press @.
4 Highlight
ANT/CABLE i n
and press 41 or _ to
select the input source
(Cable or Antenna)
for the
ANT/CABLE
input on the TV.
5 To save your new settings, highlight
Done and press
@. To revert to your original settings, highlight
CanceJ
and press o@.
Programming channels into the
TV's channel memory
CH
When you press [_] or 1_ on the remote control
or TV control panel, your TV will stop only on the
channels you programmed into the TV's channel
iTlemory.
Follow the steps below to program channels into the
TV's channel memory.
Programming channelsautomatically
Your TV can automatically detect all active channels
in your area and store them in its memory. After the
channels are programmed automatically, you can
manually add or erase individual channels in the
channel memory.
(conrin ned)