Toshiba 24SLV411U Owner's Manual page 269

Connecting an HDNJ or DVI
device to the HDN] ® input
The HDM[ input on your TV receives digital audio
and uncompressed digital video from an HDM[
source device, or macompressed digital video from
a DVI (Digital Visual Interface) source device.
This input is designed to accept HDCP (High-
Bandwidth Digital-Content Protection) wogram
material in digital form from EIA/CEA-861-D
compliant m consumer electronic devices (such as
a set-top box or DVD player with HDM[ or DVI
output). The HDMI input can accept and display
VGA, SVGA, XGA, WXGA, SXGA, 480i (60 Hz),
480p (60 Hz), 720p (60 Hz), 1080i (60 Hz), and
1080p (24 Hz / 30 Hz / 60 Hz) signal formats. For
detailed signal specifications, see page 75. Supported
Audio format: Linear PCM, sampling rate 32144.1148
kHz.
Note: To connect a PC to the HDMI input, see
page 20.
To connect an HDMI device, you will need:
• One HDM[ cable _er HDM[ device
- For proper operation, it is recommended that
you use an HDMI cable with the HDMI Logo
(H_mr )
_ To display a 1080p/80 Hz signal format,
you will need a High Speed HDMI cable.
Conventional HDMI/DVI cable may not work
properly.
- HDMI cable transfers both video and audio.
Separate analog audio cables are not
required (see illustration).
- See "Setting the HDMI ® audio mode"
(_ page 28).
To view the HDMI device video:
Select the HDMJ1 or HDMJ2 video input source on the
TV.*
* To select the video input source, press _ on the
remote control (,_ page 30).
To connect a DVI device, you will need:
• One HDM[-to-DV[
adapter cable
For proper operation, the length of an HDMI-
to-DVI adapter cable should not exceed
9.8 ft (3m). The recommended length is
6.6 ft (2m).
• One 3.5ram Stereo to RCAY-Cable
- An HDMI-to-DVI adapter cable transfers
video only. Separate analog audio cables
are required (see illustration).
See "Setting the HDMI ® audio mode"
(r:_ page 28).
TV back panel
a
v,o_o ¢oo,o
Note: To ensure that the HDMI or DVI device
is reset properly, it is recommended that you
follow these procedures:
. When turning on your electronic components,
turn on the TV first and then the HDMI or
DVI device.
. When turning offyour electronic components,
turn off the HDMI or DVI device first and
then the TV
[1]
EIA/CEA-861-D compliance covers the transmission of
uncompressed digital video with high-bandwidth digital
content protection, which is being standardized for
reception of high definition video signals. Because this is
an evolving technology, it is possible that some devices
may not operate properly with the TV.
17