Toshiba 24SLV411U Owner's Manual page 258

Integrated high definition lcd tv/dvd combination
Hide thumbs Also See for 24SLV411U:
Table of Contents

Advertisement

Removingthe Pedestal Stand
1) Carefully lay the front of the TV face down on a flat,
cushioned surface such as a quilt or blanket. Leave
the stand protruding over the edge of the surface.
Note; Extreme care should always be used
when removing the pedestal stand to avoid
damage to the LCD panel,
2) Removethe four screws shown in the below diagram.
This will allow removalof the pedestalstand.
3) Onceyou have removed all four screws, holding
the pedestal stand in place, remove the pedestal
stand from the TV.
i i
Four screws _L____
_"
24SLV411U
VESA MountingPattern
Four screws/L____J
32SLV411U
VESA Mounting Pattern
I
ii ii:iii:!iiil
Four screws
6
Hook
Sturdy strap
(as short as possible)
CAUTION:Always place the TV on the floor or a
sturdy, level, stable surface that can support the
weight of the unit. To secure the TV, use a sturdy strap
from the hook(s) on the rear of the TV to a wall stud,
pillar, or other immovable structure. Make sure the
strap is tight, secure, and parallel to the floor.
Notes on moisture condensation
Moisture condensationdamages the unit. PJease
read the following carefully.
Moisture condensation occurs, for example, when
you pour a cold drink into a glass on a warm day and
drops of water form on the outside of the glass. In
the same way, moisture may condense on this unit's
internal optical pick-up lens, one of the most crucial
internal parts of the unit.
Example
of moisture
condensation!
Moisture condensationmay occur in the following
situations:
. When you move the unit from a cold area to a warm
area.
. When you use the unit in a room in which the heat
was just turned on.
. When you use the unit in an area where cold air
from an air conditioner directly hits the unit.
. When you use the unit in a humid area.
Never use the unit when moisture condensationmay
occur.
Using the unit when moisture condensation exists
may damage discs and internal parts. Oonnectthe
power cord of the unit to the wall outlet, turn on the
unit, remove the disc, and leave it for two or three
hours. After two or three hours, the unit will have
warmed up and evaporated any moisture. Leaving
the TV connected to the wall outlet will help prevent
moisture condensation in the unit.
Wall outlet

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

32slv411u19slv411u

Table of Contents