Toshiba 24SLV411U Owner's Manual page 111

No te:
o You must configure the ANT/CABLE input source
before programming channels (_, page 26).
° Theautomaticchannelprogrammingprocess
will erase channels that were previously
programmed into the TV's memorjz
• To tune the TV to a channel not programmed in
the channel memory, you must use the Channel
Number buttons on the remote control.
° Programming channels when the ANT/CABLE
input is configured for Cable will take
substantially longer than when the antenna
input is configured for Antenna. This is
normal; however, once channel programming
is finished, you should not have to repeat
the programming process again unless your
Cable TV service lineup changes significantfi/
To program channels automatically:
1
Configure the antenna input source, if yon have
not already done so (_v page 26).
2 SETUP
Press @ and open the
Setup
menu.
3 Highlight
Installation
and press o@.
CANCEL
To cancel channel programming, press _) on the remote
control (or highlight
Cancel
in the on-screen display and
press @ ).
• . . cIt
When channel programming is finished, press _ or L_
to view the programmed channels.
Setting channelskip
To prevent certain channels from being viewed,
channel positions can be skipped.
1 From the Setup menu, highlight Installation
and
press O@.
Press A or Y to select Channel Options and press
@. The list of channels will appear.
4 A new set of JnstaJJation m enu icons will appear,
as shown below. Open the Terrestrial menu,
highlight Channel Program to bring up the
Start Scan, and press @ again to begin channel
programming.
3 Press & or V to select a channel :_osition to be
skipped and press @. A tick will appear in the
box. To remove the tick, press @ again.
To add a channel to the channel memory:
Highlight the checked box next to the channel number
yon want to add, and then press o@ to remove the tick.
To block channels in the channel memory:
You can block specific channels. You will not be able to
tune blocked channels unless you unlock them.
1 From the
Channel Options
menu, press _to move
to the channel lock list.
The TV will automatically cycle through all the
antenna channels, and store all active channels
in the channel memory. While the TV is cycling
through the channels, the message "Scanning
channels, please wait" will appear.
Press & or V to select a channel position to
be locked and then press @. Enter your four
digit PIN code. A tick will appear in the box. To
remove the tick, press @ again.
Note: If the PIN code has not been set yet, a
warning message will appea_
_CB-
3 To save the setting, press _ . (comim,,d)
27