Toshiba 24SLV411U Owner's Manual page 138

UsingCableCiear ® digital Heise
Reduction
Tile CableClear <"digital Noise Reduction feature
allows you to reduce visible interference in your
TV picture. This may be useful when receiving a
broadcast with a weak signal (especially a Cable
channel) or playing a noisy video cassette or disc.
To change the CableClear settings:
1 SETUP
Press O and open the Picture menu, highlight
Noise Reduction and press @.
2 in the CahleClear field, select your desired setting.
Note:
° if the current input is ANT/CABLE or
VIDEO, the menu will display the text
"Cab/eC/ear". The available selections are
Off, Low, Middle, and High.
o If the current input is ColorStream HD,
HDMI 1 or HDMI 2, the menu will display
the text "DNR". The available selections
are Off, Low, Middle, and High. Low,
Middle, and High will reduce the noise in
varying degrees, from lowest to highest,
respectivel_
3 To save tile new settings, highlight Doue and
press @.
To revert to the factory defaults, highlight Reset
and press @.
Using NPER Heise ReducUen
The MPEG Noise Reduction feature allows you
to reduce visible interference caused by MPEG
compression. Choices for MPEG Noise Reduction
are 0||, Low, Nidfl]e, and High. 0|f is automatically
selected when this feature is disabled ("grayed out").
To select the MPEG Noise Reduction level:
SETUP Press @ and open tile Picture menu.
Highlight Noise Reduction and press o@.
Press ,A. or V to highlight the NPEG Noise
Reductieu field and then press 41 or _ to select
either Off, Low, Niddle or High.
To save the new settings, highlight Done and
press @.
To revert to the factory defaults, highlight Reset
and press @.
Usingthe GameNode feature
You can use the Game Mode feature for shorter
frame delays when playing a video game requiring
split-second timing between the on-screen display
and input from the controller (such as music creation
and high-action games).
This feature is more effective for 480i and 1080i input
signals.
Note: To use the Game Mode feature,
the current video input must be Video,
ColorStream HD, HDMI 1 or HDMI 2. The
Game Mode cannot be turned on when
any other video input, other than the above
mentioned is selected.
To turn on Game Mode:
1 Press s_P and open the
Picture
menu, then
highlight the
Game Mode.
Press 4 or _ to select 0U.
To turn off Game Mode:
Select Off in step 2 above, change the video input, or
turn the TV off and then on again.
Note: You can change the video input by
pressing _ on the remote control
(_ page 30).
54