Sears LXI series 580.55154490 Owner's Manual page 46

VCR PLUS
TM
-t- CHANNEL MAPPING FOR CONNECTION A
Channel Mapping for Home Antenna or Cable-TV
(no cable box)
Use these Channel Mapping instructions only if your
VCR connected as shown in Connection A on the
previous page.
TO MAP CHANNELS
_)Autoprogram the VCR's channel memory as
decribed on page 24.
OPress the VCR Plus+ button on the remote
control twice to display the main menu.
Only channels that are assigned a VCR Plus+ guide
number different than the number you select to
watch that channel on your TV require map. A chart
of the assigned VCR Plus+ guide numbers is usually
published in your local TV listings or TV Guide.
Check the list of VCR Plus+ guide numbers for your
area to see if any of the assigned numbers are
different than the channel number you select on your
TV.
Home Antenna Mapping: If you have connected a
home antenna to your VCR, most channels probably
do not require any map. If the published VCR Plus+
guide numbers are all the same as the channel
number you select when you watch that station, no
map is necessary. You can skip the map information
on these two pages.
Cable-TV Mapping: If you have connected a cable-
I-V system to your VCR, you will map any channel
that has a VCR Plus+ guide number different than
the number you select to watch that channel on your
-IV.
BEFORE MAPPING CHANNELS
First press
VCR Plus+.
VCR PLUS
PROGRAM
MENU will
appear.
VCR PLUS PROGRAM
PUSH VCR PLUS CODE:
TO ENTER PUSH DISPLAY
TO END PUSH VCR PLUS
Then press VCR
Plus+ again.
(without VCR PLUS
code)
VCR PLUS
MAIN MENU
will appear.
m_
VCR PLUS PROGRAM
PUSH SELECTION NUMBER
1 VCR PLUS PROGRAM
2 PROGRAM REVIEW
3 CHANNEL MAPPING
4 CABLE BOX
5 CABLE BOX SET UP O)
(N
TO END PUSH VCR PLUS
Press 3 to begin channel Mapping process. The
following display will appear on the TV screen.
o You can map channels from only one TV
system(TV or CATV) at a time.
Make sure that you have selected the correct TV
system.
• On a piece of paper, write down which channels in
your TV listings correspond to the channels you
receive.
• Turn on the power of both VCR and TV.
Make sure the TV is set to the VCR output
channel 3 or 4.
• Aim the remote control at the receiver on the front
of the VCR.
- 45 -