Identification And Operation Of Controls - Sears LXI series 580.55154490 Owner's Manual

IDENTIFICATION AND OPERATION OF CONTROLS
Now that you have experienced the simple operation of your VCR, let's get familiar with the complete operation
of your VCR and all its capabilities.
I REAR ]
"VHF/UHF INPUT"
Lead wire from antenna connects to this 75-
ohm input.
®
VIDEO OUT and AUDIO OUT (L and R)
_ These jacks are used to send signals from the
VCR to another device.
IN FROM ANT T
=--
OUT TO IV
CH3 CH4
rlrlrlrlrll]
rlrlrlrlrlrl_rlrl
rlri0rlrlrlrlrl0rl0
i]i-trlll fli-ii] r l0
II
\
I I
J
®
€
VIDEO IN and AUDIO IN (L and R)
These jacks are used to receive signals from
another device (such as a camcorder or another
VCR).
To see and hear the signal from these jacks,
press the "INPUT SELECT" button to light the
"r'_ "indicator in the VCR's display panel.
"VHF/UHF OUTPUT"
75-ohm round Cable Connector connects to this
output. Opposite end of cable connects to the
television through the Antenna Splitter if
necessary (not supplied).
RF CHANNEL SELECT SWITCH
Slide the switch to "CH3" or "CH4" to match the
channel selector on your TV. This is the VCR
channel on your television set.
-10-