Connections To The Vx-2000D And Dhd Controller; Connector Panel Access; Connecting The Projector To The Dhd Controller - Runco Video Xtreme VX-2000d Operating Manual

Proceed as follows to connect the DHD Controller to the VX-2000d, your video sources,
external controller(s) – if present – and AC power.
When connecting your equipment:
• Turn off all equipment before making any connections.
• Use the correct signal cables for each source.
• Ensure that the cables are securely connected. Tighten the thumbscrews on
connectors that have them.
You can access the VX-2000d connector panel through either the cable opening at the
bottom rear of the projector (see Figure 2-1) or the rear connector panel access door.
The VX-2000d is designed to receive only video input signals directly from the companion
DHD Controller/Processor. Connect all signal sources to the appropriate inputs on the
rear panel of the DHD. The signal from the DHD is then output to the VX-2000d projector
through an HDMI cable.
You CANNOT connect signal sources directly to the VX-2000d.
Note
They MUST be routed through the DHD Controller for proper
operation.
Connect the HDMI and RS-232 outputs of the DHD Controller to the corresponding inputs
of the VX-2000d; see Figure 3-6.
Figure 3-6. Connecting the Projector to the DHD Controller
Runco VX-2000d Owner's Operating Manual 25
Installation
3.5
Connections to the
VX-2000d and DHD
Controller

Connector Panel Access

Connecting the Projector
to the DHD Controller