Changing The Rate Of The Pitch Change (Bend) - Roland Groovebox MC-307 Reference Manual

between strongly played and softly played notes will
gradually increase.
With positive (+) settings, the volume will increase as you
play more strongly on the keyboard. With negative (-)
settings, the volume will decrease as you play more strongly
on the keyboard. If this is set to "0," the volume will not be
affected by the strength of your playing on the keyboard.
Range: -100– +150
A-ENV: VELO TIME SENS (VELOCITY TIME
SENSE)
Specifies how the dynamics of your playing will affect
TIME1–4.
Specifies the time until the next level is reached. You can
make settings for the four parameters TIME 1–4.
Raising this setting will also raise the Level.
Range: -100– +100
With positive (+) settings, time will become faster as you
play the keyboard more strongly. With negative (-) settings,
time will become slower as you play the keyboard more
strongly.
A-ENV: TIME1–4 (ENVELOPE TIME1–4)
Specifies the time until the next level point is reached. You
can make settings for the four parameters TIME 1–4.
Higher settings will lengthen the time until the next level
point is reached.
Range: 0–127
Level
+
Time1(A) Time2 Time3(D)
0
Level1 Level2
Key on
A-ENV: LEVEL1–3 (ENVELOPE LEVEL1–3)
These parameters specify the volume at each point. You can
set the three points Level1–3.
Higher settings will also raise the volume.
Range: 0–127
Time4(R)
Time
Level3(S)
Key off
Chapter 6 Making Original Patches
Changing the Rate of the Pitch
Change (BEND)
Specifies the amount of pitch change (in semitone units) that
will occur when the pitch bend lever of an external MIDI
device is operated.
Higher settings will result in a greater pitch change when the
pitch bend lever is moved to the left or right.
For example, if Bend Range Up is set to "+12," the pitch will
rise one octave when the pitch bend lever is moved to the
right-most position.
Procedure
1. Press the [PTN] button.
2. Press [PART SELECT] then, Press [R] part buttons to
select the part R.
3. Press [F1 (PACH)] and [F1 (EDIT)] button, in that order.
4. The menu screen for rhythm set editing appears.
5. Press the [CURSOR (down)] button.
6. Press the [F1 (BEND)] button.
7. Press the [F1 (BEND)] button again.
8. Press an appropriate keyboard pad to select the key for
which you want to define the parameter.
(You can listen to the sound to confirm which tone is
selected.)
9. Specify a value using the [VALUE] dial or the [INC/
DEC] buttons.
10. After the value is specified, press the [EXIT] button to
return to the previous screen.
Range:
- Bend Range: 0–12
111