Roland Groovebox MC-307 Reference Manual page 124

Chapter 7 Environment Configuration and
2. Press the [CURSOR (up)] button to access the screen for
items 1–4.
3. Press the [F4 (MIDI)] button.
4. Press [CMMN] button.
If the following screen is not displayed, use [F4 (
make it appear.
5. Use the [CURSOR (up/down)] button to move the cursor
to "THRU."
6. Specify a value using the [VALUE] dial or the [INC/
DEC] buttons.
Range: OFF, ON
Parameter Type: Backup parameters
Specifying the channel that will control
arpeggios (ARPEGGIO CTRL CH)
If the remote keyboard switch is set to "OFF" (that is, if the
system is set to receive data from an external MIDI keyboard
as they are on MIDI channels), this operation specifies which
channel on the external MIDI equipment is used as the
source of note information for controlling arpeggio.
When note messages on the specified channel are received
from an external device, an arpeggio will be generated based
on those notes, and played by the current part.
With the factory settings this is set at "16."
Procedure
1. Press the [SYSTEM] button, then the [F1 (SYS)] button.
The selection screen for system settings appears.
2. Press the [CURSOR (up)] button to access the screen for
items 1–4.
3. Press the [F4 (MIDI)] button.
4. Press the [F1 (CMN)] button.
If the following screen is not displayed, use [F3 (
make it appear.
5. Use the [CURSOR (up/down)] button to move the cursor
to "ARPEGGIO CTRL CH."
6. Specify a value using the [VALUE] dial or the [INC/
DEC] buttons.
Range: OFF, 1–16
124
Parameter Type: Backup parameters
- refer to Playing back arpeggio on the MC-307 using an
external MIDI keyboard (p. 134).
* If the Remote Keyboard Switch is "ON," you can play
arpeggios on the current part simply by turning the
)] to
arpeggiator on.
Specifying the channel that will control
RPS (RPS CTRL CH)
This specifies the channel that note messages arriving from
an external MIDI device need to be using in order to control
RPS when the Remote Keyboard Switch is "OFF." When note
messages on the specified channel are received from an
external device, RPS will play.
With the factory settings this is set at "15."
Procedure
1. Press the [SYSTEM] button, then the [F1 (SYS)] button.
The selection screen for system settings appears.
2. Press the [CURSOR (up)] button to access the screen for
items 1–4.
3. Press the [F4 (MIDI)] button.
4. Press the [F1 (CMN)] button.
If the following screen is not displayed, use [F3 (
make it appear.
5. Use the [CURSOR (up/down)] button to move the cursor
to "RPS CONTROL CH."
6. Specify a value using the [VALUE] dial or the [INC/
DEC] buttons.
Range: OFF, 1–16
Parameter Type: Backup parameters
- refer to Playing back RPS on the MC-307 using an
)] to
external MIDI keyboard (p. 133).
* If the Remote Keyboard Switch is "ON," this setting is
ignored.
)] to