Attachments; Troubleshooting - RIDGID WTS2000L Operator's Manual

ATTACHMENTS

Item Part Name
1 Nut Wrench
 Hex Wrench

TROUBLESHOOTING

WARNING:
For your own protection, turn the ON/OFF switch to "OFF," and always remove the plug from power-source outlet
before troubleshooting.
TROUBLE
Motor stops running
The water pump cannot
inject water
LED Lights/Laser Beam
projection is hard to see
LED Lights/Laser beam
projection doesn't work
Frequent tripping of
overload protector
QuaNtIty
1
1
PROBABLE CAUSE
There is no power to the electrical outlet.
Low voltage.
Plugs aren't fully connected to the power
source.
Switch isn't "ON."
The carbon brushes have worn out
completely.
GFCI is tripped.
Overload protector tripped.
The water-pump plug is not firmly connected
to the saw receptacle.
There is not enough water in the water tray.
The water hose is loose or off.
The water valve is in "OFF" position.
The water hose or water nozzle is jammed.
The water pump filter is too dirty.
The water pump is damaged.
Light in work area is too bright.
Dust or water is on the laser-aperture cover or
on the surface of LED lights.
The LED Lights /LASER switch isn't turned
on.
Rapid feeding of material into the cutting
blade
Low voltage and heavy load
SOLUTION
Make sure that the outlet has power.
Check that the power source voltage is 10V.
Verify that the plugs are securely connected.
Lift the ON/OFF switch to turn the saw on.
Replace the carbon brushes.
Press the ON/OFF switch down to turn the
saw off; reset the button on the GFCI.
Press the overload-protector switch to restart
the saw.
Connect the water-pump plug to the saw
receptacle.
Make sure that the water-pump intake is fully
immersed in water.
Reconnect the water hose to the pump.
Turn the valve to the "ON" position.
Clean the water hose or water nozzle, or
replace them.
Clean the water-pump filter.
Replace the water pump.
Move the machine to a work area where the
light isn't as bright.
Wipe the dust or water off with a clean, soft
cloth.
Turn on the LED/LASER switch.
Feed the material more slowly into the
cutting blade
When cutting extremely dense materials,
make sure that power supply voltage is
exactly 10 V
36