Glossary Of Terms; Motor Specification And Electrical Requirements; Power Supply And Motor Specification - RIDGID WTS2000L Operator's Manual

GLOSSARY OF TERMS

Arbor
The shaft on which a cutting tool is mounted.
Bevel Cut
A cutting operation made across the width of the work piece
in which the cut is not perpendicular to the surface of the
work piece.
Flat Angle Cut
An angle-cutting operation made through the face of work
piece: The cut is perpendicular to the surface of the work
piece and is at an angle other than 90° to the edge of the
tile.
Freehand
Performing a cut without using a rip fence (guide), fixture,
hold-down, or other proper device to prevent the work piece
from twisting during the cutting operation. Never cut free-
hand with this tool.
Off-Cut
The portion of the work piece that has been cut off.
MOTOR SPECIFICATIONS AND ELECTRICAL REQUIREMENTS
Power Supply And Motor Specifications
WARNING:
To reduce the risk of electrical hazards, fire hazards, or
damage to the tool, use a ground-fault circuit interrupt-
er. If the power cord is worn, cut, or damaged in any
way, replaced it immediately to reduce the risk of shock
or fire
The motor is wired for operation on 10v AC, 60 Hz service.
Rate H.P.
Voltage
Amperes
Hertz (Cycles)
Phase
RPM
-1/
10V
15
60
Single
400
Table 
Plunge Cut
A cutting operation in which the rotating blade is lowered
onto the work piece.
Revolutions Per Minute (RPM)
The number of turns completed by a spinning object in one
minute.
Straight Cut
A cutting operation parallel to the one straight edge of the
work piece.
Work Piece
The item on which the cutting operation is being performed.
The surfaces of a work piece are commonly referred to as
faces, ends, and edges.
Through-Sawing
Any cut that completely severs the work piece.
General Electrical Connections
WARNING:
To reduce the risk of electrocution:
1. Use only identical replacement parts when servic-
ing. Servicing should be performed only by a quali-
fied, service technician.
2. Do not use in rain or where the floor is wet. This tool
is intended for indoor, residential use only.
WARNING:
Do not permit fingers to touch the terminals of plug when
installing or removing the plug to or from the outlet.
9