Stand Set Up - RIDGID WTS2000L Operator's Manual

ASSEMBLY
Stand Set-Up, continued
5. Tighten the locking nut (Fig 8). Make sure all connec-
tions are firm and the stand is steady.
6. The stand anchors located on the two shorter legs (Fig.
9) may be used to attach the stand to the floor with
screws (not supplied).
Closing the Stand
From the side of the stand with two wheels, first pull out the
orange knob at the end of the crossbar, as shown in Fig. 10,
then reverse the steps described in "To Open the Stand,"
page 13.
14
Locking Nut
Fig. 8
Stand Anchors
Fig. 9
Fig. 10