Laser Beam Calibration - RIDGID WTS2000L Operator's Manual

ADJUSTMENTS

Laser Beam Calibration

Press the laser switch to turn on the laser (Fig. 36).
To adjust the alignment and angle of the laser beam, turn the
right knob (Laser ANGLE Adjustment) and the left knob
(Laser ALIGNMENT Adjustment) alternately until the laser
beam goes across the two ▲ marks engraved in the slot of
the work table (Fig. 37, Fig. 38).
WARNING:
DO NOT stare directly at the laser beam. Never aim the
light at any person or at any object other than the work
piece.
NOTE: If you want to use laser as a cutting guide, make sure
that the laser beam is aligned with the cutting line.
LASER SWITCH LASER SWITCH
8
LASER ALIGNMENT LASER ALIGNMENT
ADJUSTMENT KNOB ADJUSTMENT KNOB
LASER ANGLE
ADJUSTMENT KNOB
ENLARGEMENT OF ENLARGEMENT OF
ALIGNMENT TRIANGLES ALIGNMENT TRIANGLES
Fig. 36
Fig. 37
Fig. 38