Adjustments; Depth Adjustment; Depth-Stop Adjustment - RIDGID WTS2000L Operator's Manual

ADJUSTMENTS

WARNING:
For your own safety, turn the switch to "OFF" and remove
the plug from the power-source outlet before making
any adjustment.
Depth Adjustment (Fig. 9)
Use the depth-adjustment knob to adjust the lowest posi-
tion of the blade:
1. Loosen the depth-stop-adjustment knob and the lock-
ing nut (located under the depth-adjustment knob).
. Use the handle to lower the cutting head to its lowest
position.
3. Turn the depth-adjustment knob to raise or lower the
lowest position of the blade.
4. Tighten the locking nut.
5. Tighten the depth-stop-adjustment knob.
To cut all the way through the work piece, make sure that
the lowest position of the blade is 3/16" (5 mm) below the
surface of the work table (Fig. 30).
Depth-Stop Adjustment (Fig. 31)
The depth-stop-adjustment knob is used to lock the cutting
head in position.
1. Loosen the depth-stop adjustment knob.
. Hold the handle to raise or lower the saw blade to the
desired position.
3. Turn the knob to lock the cutting head in place.
Depth Stop Depth Stop
Adjustment Adjustment
Knob Knob
Depth Depth
Adjustment Adjustment
Knob Knob
BLADE
SURFACE OF WORKING TABLE
5
Locking
Nut
Fig. 9
BLADE RIM
3/16" (5mm)
Fig. 30
Fig. 31