Moving The Saw - RIDGID WTS2000L Operator's Manual

OPERATION

Moving the Saw

WARNING:
Before moving the saw with the stand or folding the
stand, make sure that the work table is locked with the
table lock and that the saw is securely fastened to the
stand with the two screws. Please see "Mounting Your
Saw" on page 17 of this manual. Failure to do so may
result in serious personal injury.
1. Remove the extension table and invert it on the work
table. Align the hole in the extension table with the hole
in work table, pull out the pin attached to the extension
table, and lock the extension table on the work table by
inserting the pin into the holes (Fig. 48).
. Unlock the wheels on the stand.
3. Hold the handle of the stand firmly, lift the stand, and
make sure that the two legs without wheels are about
1/ inch above the ground (Fig. 49).
4. The stand may also be fully or partially folded, as shown
in Fig. 50 and Fig. 51. To fold the stand, please see
"Closing the Stand" on page 14.
5. Move the stand carefully to the desired location (if the
legs are folded, unfold the legs), and put it down gently
until the two legs without wheels contact the ground.
6. Lock the two wheels of the stand.
Fig. 48
34
Fig. 49
Fig. 50
Fig. 51