Depth Stop; Headstock Movement; Raising/Lowering Headstock - Grizzly G0755 Owner's Manual

Depth Stop

the depth stop limits the downward movement of
the cutting tool. With the use of the depth pointer
adjustment knob (see D in Figure 12), it can be
adjusted anywhere within 0"–5". this is useful
when performing repeat operations.
Headstock
Movement
the headstock travels up and down the column,
and tilts 90° left and right relative to the table.

Raising/Lowering Headstock

Loosen the lock handles shown in Figure 13, then
use the elevation (z-Axis) switch (see Figure 14)
on the control panel to raise/lower the headstock.
Figure 13. Lock handles for headstock elevation.
Figure 14. elevation switch that controls
motorized head travel.
Model G0755 (Mfg. Since 1/13)
The z-axis crank will rotate rapidly and may
cause impact injuries if left attached during
powered z-axis operation. Always remove
z-axis crank before using the switch on the
control panel.
the limit stops shown in Figure 15 stop head-
stock travel when contacted by the limit block.
the headstock can also be raised/lowered by
hand using the crank shown in Figure 16.
Lock
handles
elevation
switch
Note: Lock the headstock in place by re-tighten-
ing the lock handles before beginning operation to
avoid unexpected headstock movement.
Limit
stops
Figure 15. z-axis limit controls.
Crank
Figure 16. z-axis crank.
Limit
Block
-21-