Adjusting Depth Stop Rod - Grizzly G0645 Owner's Manual

9.
Place a square against the fence and chisel,
as shown in Figure 21, to verify that the
chisel is square to the fence.
Figure 21. Squaring chisel to fence.
— If the chisel is not square to the fence,
loosen the chisel lock set screw, twist the
chisel into alignment, then tighten the set
screw.
10. Close the chuck access door and carefully
tighten the fence lock handles, making sure
the fence does not move.
— If the fence does move, repeat Steps 7 &
8.
G0645 Benchtop Mortising Machine
Adjusting Depth
Stop Rod
When adjusted correctly, the depth stop rod
ensures that the mortise is not cut too deep and
repeated mortise depths are consistent. Always
make the mortise at least an
tenon to allow room for excess glue.
To adjust the depth stop rod:
1. Loosen the depth lock lever, lower the chisel
until it contacts the top of the workpiece.
2. Adjust the depth stop using one of the meth-
ods below:
• Adjust the depth stop rod above the col-
umn to the desired depth of the mortise cut,
using a ruler, as shown in Figure 22 and
then tighten the lock lever.
Figure 22. Adjusting depth stop using ruler.
• Another method of setting the depth stop is
to mark the depth of the mortise cut on the
side or front of the workpiece with a pencil,
lower the bottom of the chisel to the line,
as shown in Figure 23, then lock the depth
stop.
Figure 23. Depth marked on workpiece.
⁄ " deeper than the
1
8
Depth Mark
-19-