Table of Contents
Advertisement
Installing/
Removing Bits
Any drill bit you install in the chuck must
be tight enough that it will not come loose
during operation.
To install/remove bit:
1. DISCONNECT TOOL FROM POWER!
2. Open drill chuck wide enough to
release bit and accept new bit shank.
3. Insert bit as far as possible into chuck
WITHOUT allowing chuck jaws to
touch fluted portion of bit, then hand-
tighten chuck (see Figure 8).
Note: Make sure small bits are not
trapped between edges of two jaws; if
they are, re-install drill bit or it will not be
secure enough to use for drilling.
4. Tighten chuck firmly with chuck key
(see Figure 8).
Chuck Key
Figure 8. Drill bit installed in chuck.
Adjusting
Headstock Position
The headstock moves vertically and pivots
around the column.
Model T32006 (Mfd. Since 01/20)
Chuck
Drill Bit
To adjust headstock position:
1. DISCONNECT TOOL FROM POWER!
2. While holding headstock, loosen head-
stock lock handle shown in Figure 9.
Figure 9. Headstock lock handle location.
3. Adjust headstock to desired position,
then tighten lock handle to secure.
Adjusting Depth Stop
The depth stop allows you to drill holes to
the same depth every time.
To adjust depth stop:
1. DISCONNECT TOOL FROM POWER!
2. Loosen set screw shown in Figure 10
before lowering bit to desired height.
3. Rotate lock ring counterclockwise until
it stops (see Figure 10), then tighten
set screw from Step 2 to secure depth.
Figure 10. Depth stop components.
Headstock
Lock Handle
Lock Ring
-17
-
Advertisement
Table of Contents
