Depth Stop - Grizzly G0793 Owner's Manual

3. While holding tooling, raise spindle to origi-
nal position. Tooling should automatically
release from spindle.
4. Pull automatic drift knob to OUT position.
Removing Tooling Manually
1. DISCONNECT MACHINE FROM POWER!
2.
Lower quill and rotate spindle by hand until
drift key holes in spindle and quill are aligned
(see Figure 17).
Drift Key
Hole
Figure 17. Spindle and quill drift key holes
aligned.
3. Insert drift key into aligned holes and allow
quill to rise, trapping drift key.
4. Use rubber or wooden mallet to softly tap end
of key while holding arbor/chuck assembly
until it separates from spindle (see Figure
18).
Figure 18. Using drift key to remove arbor.
Model G0793 (Mfd. Since 02/15)
This drill press includes a depth stop for drilling
multiple holes to the same depth.
To set depth stop:
1.
DISCONNECT MACHINE FROM POWER!
2.
Adjust table height so workpiece is close to
tooling.
3.
Mark side of workpiece at intended cutting
depth (see Figure 19).
Quill
Scrap Wood
Figure 19. Depth stop mark on workpiece.
4.
Secure workpiece and scrap wood to table
with a clamp or vise.
5.
Lower spindle until tip of bit is even with mark.
6.
Loosen depth stop knob and position so it
rests on downfeed engagement lever, then
tighten depth stop knob (see Figure 20).

Depth Stop

Downfeed
Engagement
Depth Stop
Workpiece
Knob
Lever
Figure 20. Setting depth stop knob.
Drill Bit
Workpiece
Depth
Mark
Table
-23-