Y-Axis Handwheels; X-Axis Power Feed - Grizzly G0755 Owner's Manual

X- & Y-Axis Handwheels
use Figure 21 and the following descriptions to
become familiar with the X- and y-axis manual
table movement.
B
A
Figure 21. table locks and limit stops.
A. Y-Axis Handwheel: Moves table back and
forth.
b. X-Axis Table Locks: increase rigidity of
table when X-axis movement is not required
for operation.
c. Y-Axis Table Lock: increase rigidity of table
when y -axis movement is not required for
operation.
D. X-Axis Handwheel: Moves table side to
side.
Model G0755 (Mfg. Since 1/13)
d
C

X-Axis Power Feed

use Figures 22–23 and the following descriptions
to become familiar with the power feed controls.
B
A
F
Figure 22. X-axis power feed controls.
g
h
Figure 23. Limit switch and limit stops.
A. ON/OFF Light: Lights when unit is turned
ON.
b. Direction Lever: Controls direction of pow-
ered table travel.
c. Rapid Switch: When held down, moves
table rapidly in chosen direction.
D. Power Light: Lights when unit is connected
to power.
E. Speed Dial: Controls rate of power feed.
F. ON/OFF Switch
G. X-Axis Limit Stops: Adjustable along front
of table to restrict X-axis table movement,
particularly when using the power feed.
H. Limit Switch: stops power feed when con-
tacted by a limit stop.
C
d
e
-23-