Table of Contents
Advertisement
Lifting & Placing
Straining or crushing injury
may occur from improperly
lifting machine or some of
its parts. To reduce this risk,
get help from other people
and use a fork lift (or other
lifting equipment) rated for
weight of this machine.
power lifting equipment, steel rods (refer to
Page 11), and at least two other people are
required to lift and place the mill.
To move your machine into position:
1.
Move shipping crate next to mounting loca-
tion, then unbolt machine from pallet.
2.
to help balance machine during moving,
position table as close to column as possible,
and adjust headstock to its lowest position.
3.
insert steel rods into holes in stand, as shown
in Figure 5.
Figure 5. Lifting setup.
-14-
HEAVY LIFT!
steel rods
4.
evenly position forklift forks under steel rods
on each side of cabinet.
Note: Before next step, make sure all locks
are tight to avoid sudden shifts which could
unbalance machine.
5.
With help of additional people to steady load,
slowly lift machine, remove pallet, then lower
machine into position.
Model G0755 (Mfg. Since 1/13)
Advertisement
Table of Contents
