Adjusting Headstock Position; Setting Depth Stop - Grizzly G0823 Owner's Manual

Adjusting Headstock
Position
The headstock travels up and down the column,
and rotates 360° around the column. Before
adjusting headstock position, fully retract the
quill and set the headstock as low as possible to
increase quill rigidity and reduce vibration.
To adjust headstock position:
1.
DISCONNECT MACHINE FROM POWER!
2.
Use included lug wrench to loosen both
headstock lock nuts shown in Figure 23.
Headstock
Lock Nuts
Figure 23. Loosening headstock lock nuts in
order to adjust headstock position.
3. Use headstock elevation crank (see Figure
24) to move head up or down as desired. Use
your hands to rotate headstock on column as
needed.
Headstock
Elevation Crank
Figure 24. Location of headstock elevation
crank.
4. Retighten headstock lock nuts.
-26-

Setting Depth Stop

The depth stop is used to limit the range of tooling
downward movement or drilling depth. Maximum
depth is 5 ⁄ ".
1
8
To set depth stop:
1. DISCONNECT MACHINE FROM POWER!
2. Install tooling (refer to Page 25), then make
sure spindle is drawn all the way up into
headstock.
3. Loosen headstock lock nuts (see Figure 23)
and lower head using headstock elevation
crank (see Figure 24) until drill bit or cutter
is approximately ⁄
1
retighten headstock lock nuts.
4. Rotate knurled knob (Figure 25) until top of
indicator is level with desired depth as listed
on scale.
Note: The depth stop scale functions as a
general guide only. It is not intended for high-
tolerance, precision results. To calibrate the
depth stop, see Calibrating Depth Stop on
Page 36.
Figure 25. Depth stop controls.
Model G0823 (Mfd. Since 2/16)
" above workpiece, then
8
Indicator
Knurled
Knob