Table of Contents
Advertisement
1 – Introduction
Features
1.3
Features
Compliance with PCI Local Bus Specification revision 2.2 and PCI-X
■
Specification revision 1.0a
Supports the IETF iSCSI standard, with soft upgrades as the standard evolves
■
32/64-bit, 33/66/133-MHz universal PCI-X
■
1-Gbps, full-duplex Ethernet
■
Complete TCP/IP protocol off-load
■
iSCSI initiator and target modes
■
RJ45 Gigabit Ethernet connector (QLA4010C HBA)
■
Small form factor (LC) fiber optic connector (QLA4010 HBA)
■
1.4
Technical Support
Customers should contact their authorized maintenance provider for technical
support of their QLogic switch products. QLogic-direct customers may contact
QLogic Technical Support; others will be redirected to their authorized maintenance
provider.
Visit the QLogic support Web site listed in
software updates.
1.4.1
Availability
QLogic Technical Support is available from 7:00 AM to 7:00 PM Central Standard
Time, Monday through Friday, excluding QLogic-observed holidays.
1.4.2
Training
QLogic offers certification training for the technical professional for both the
SANblade™ HBAs and the SANbox switches. From the training link at
www.qlogic.com, you may choose Electronic-Based Training or schedule an
intensive "hands-on" Certification course.
Technical Certification courses include installation, maintenance and
troubleshooting QLogic SAN products. Upon demonstrating knowledge using live
equipment, QLogic awards a certificate identifying the student as a Certified
Professional. The training professionals at QLogic may be reached by email at
tech.training@qlogic.com.
1-2
section 1.4.3
PRELIMINARY
Q
for the latest firmware and
IS0053302-00 7
Advertisement
Table of Contents
Need help?
Do you have a question about the QLA4010 and is the answer not in the manual?