4 – Windows Server 2003 Driver Installation
Installing the Driver
b. To download the driver from the QLogic web site, follow these steps:
2. Insert a blank disk in drive A.
3. Run the self-extracting file you just downloaded, specifying A:\ for Unzip To
Folder. Make sure the files listed in
4.4
Installing the Driver
This section is divided into the following three sections:
Initial OS Installation with the QLA4010/4010C HBA as an Add-on Device
■
Adding the QLA4010/4010C HBA to the Existing OS
■
Updating the Existing Driver
■
NOTE:
4.4.1
Initial OS Installation with the QLA4010/4010C HBA as an Add-On Device
NOTE:
Perform the following steps to install Windows Sever 2003 and the QL4010.SYS
driver when the QLA4010/4010C HBA is attached to a nonbootable device:
1. Start the Windows Sever 2003 installation procedure using the Setup disks or
CD.
2. If you are booting from the CD and the following message displays, press F6:
Press F6 if you want to install a third party SCSI or RAID Driver...
4-2
Locate the driver you want on the QLogic web site (www.qlogic.com) and
❑
click Download.
When prompted Would you like to open the file or save it to your
❑
computer?, click the Save button. Specify a temporary location on the
hard drive and download the driver.
The system cannot boot from the device attached to the QLA4010/4010C
■
HBA.; consequently, the operating system (OS) cannot be installed on the
device attached to the QLA4010/4010C HBA.
The QLA4010 is a multifunction PCI device. Function 1 refers to the
■
QLogic iSCSI initiator device.
The system cannot boot from a device attached to the QLA4010/4010C
■
HBA; consequently, the operating system (OS) cannot be installed on the
device attached to the QLA4010/4010C HBA.
You must create a driver disk
■
the QL4010.SYS driver. You cannot install the QL4010.SYS driver directly.
PRELIMINARY
section 4.2
are on the disk.
(see section 4.3)
when installing the OS and
Q
IS0053302-00 7
Need help?
Do you have a question about the QLA4010 and is the answer not in the manual?