Restoring The Factory Defaults; Firmware Upgrade - Qlogic QLA4010 User Manual

6 – SANsurfer Control iX
Configuring the Firmware
6.6.2

Restoring the Factory Defaults

Perform the following steps to reset the firmware parameters to the factory defaults:
1. Click the desired adapter in the HBA tree. By default, the HBA Options tabbed
page displays.
2. Click the Firmware tab.
3. Click Restore Factory Defaults. The defaults are displayed in the firmware
parameters table
6.6.3

Firmware Upgrade

If you are receiving a QLA4010/4010C HBA for the first time, the current version of
firmware is already loaded.
If you are upgrading a QLA4010/4010C HBA, follow the instructions in this section
to load the latest firmware from the QLogic web site. The HBA Information tab in
SANsurfer Control iX displays the firmware version you are using.
To upgrade the firmware, follow these steps:
1. Locate the iSCSI firmware on the QLogic web site (www.qlogic.com) and click
Download.
2. When prompted Would you like to open the file or save it to your
computer?, click the Save button. Specify a temporary location on the hard
disk and download the file.
3. In the temporary directory, locate the file, qla4000fwxx.exe. Double-click the
file to extract it to a specified directory.
4. Start SANsurfer Control iX: click Start, select Programs, select the install group
(the default is QLogic Corporation), then click SANsurfer Control iX.
5. Select your HBA.
6. Click the HBA Options tab.
7. Click the Firmware tab.
8. Click the Select Firmware to Download button.
6-36
(see figure 6-26).
PRELIMINARY
Q
IS0053302-00 7