Chap Tabbed Page - Qlogic QLA4010 User Manual

6 – SANsurfer Control iX
Configuring Targets
4. At the prompt, enter your password. The CHAP tabbed page displays
figure
5. Select the Enable check box for the targets for which you want to use CHAP.
6. Enter the initiator name and secret you want to use in the Initiator Name and
Initiator Secret columns.
7. CHAP is now enabled; the target will use CHAP to authenticate the
QLA4010/4010C HBA. If you also want the QLA4010/4010C HBA (initiator) to
authenticate the target, perform the following steps:
a. Select the Bidi check box of the target you want to configure.
b. In the Target Table portion of the page, click the green plus sign (+) on the
c. Double-click the row in the Target Name column. Enter the target name,
d. Double-click the row in the Target Secret column. Enter the target secret,
e. Repeat
6-30
6-25).
Figure 6-25. CHAP Tabbed Page
right. A blank row displays.
which can be a maximum of 256 ASCII characters. This name must be
entered on the target side (Name) for bidirectional CHAP.
which can be a maximum of 100 ASCII characters. This target secret must
be entered on the target side (Password) for bidirectional CHAP.
steps a through
to remove a target from the Target Table, click the row you want to remove,
then click the minus sign (–) on the right.
PRELIMINARY
d for each target you want to configure. If you want
Q
(see
IS0053302-00 7