Qlogic Fast Fabric User Manual page 83

Q
output in the same order even if components have been rebooted. This is useful
for comparison using simple tools like diff. iba_report permits multiple
reports to be requested for a single run (i.e., 1 of each report type).
By default iba_report uses the first active port on the local system. However,
if the IB management node is connected to more than one fabric (e.g., a subnet),
the HCA and port may be specified to select the fabric to analyze.
Usage:
iba_report [-v][-q] [-h hca] [-p port] [-o report] [-d detail]
[-P|-H] [-N] [-x] [-s] [-i seconds] [-C] [-a] [-c file] [-L]
[-F point] [-S point] [-D point] [-Q]
-v/--verbose - verbose output
-q/--quiet - disable progress reports
-h/--hca hca - HCA to send via, default is 1st HCA
-p/--port port - port to send via, default is 1st active port
-o/--output report - report type for output
-d/--detail level - level of detail 0-n for output, default is 2
-P/--persist - only include data persistent across reboots
-H/--hard - only include permanent hardware data
-N/--noname - omit node and IOC names
-x/--xml - output in XML
-s/--stats - get performance statistics for all ports
-i/--interval seconds - obtain performance statistics over interval
seconds, clears all statistics, waits interval seconds, then generates report.
Implies -s
-C/--clear - clear performance stats for all ports. Only stats with error
thresholds are cleared. A clear occurs after generating the report.
-a/--clearall - clear all performance stats for all ports
-c/--config file - error thresholds configuration file. The default is
/etc/sysconfig/iba/iba_mon.conf
-L/--limit - For port error counters check (-o errors) and port counters
clear (-C or -i) with -F limit operation to exact specified focus. Normally the
neighbor of each selected port would also be checked/cleared does not affect
other reports
-F/--focus point - focus area for report used for all reports except route
to limit scope of report
-S/--src point - source for trace route, default is local port
D000006-000 Rev A
5 – Detailed Descriptions of Command LineTools
5-29