Qlogic Fast Fabric User Manual page 19

Q
SilverStorm Technologies Inc. InfiniBand 4.1.1.0.15 Software
1) Show Installed Software
2) Reconfigure IP over IB
3) Reconfigure Driver Autostart
4) Update HCA Firmware
5) Generate Supporting Information for Problem Report
6) Host Setup via Fast Fabric
7) Host Admin via Fast Fabric
8) Chassis Admin via Fast Fabric
9) Externally Managed Switch Admin via Fast Fabric
a) Uninstall Software
X) Exit
In the above menu, items 6-9 represent the Fast Fabric menus. The operation of
this menu is the same as the INSTALL and iba_config functions documented in the
QuickSilver Fabric Access Users Guide. Pressing a key 1-9 or a will invoke the
given submenu. Pressing X will exit the menu system.
Selection of a Fast Fabric menu (6-9) will present a submenu similar to the following:
SilverStorm Technologies Inc. IB Host Setup Menu (4.1.1.0.15)
Fast Fabric Host List: /etc/sysconfig/iba/hosts
0) Edit Config and Select/Edit Hosts Files
1) Verify Hosts via Ethernet ping
2) Verify rsh/rcp Configured
3) Setup Password-less ssh/scp
4) Copy /etc/hosts to all hosts
5) Show uname -a for all hosts
6) Install/Upgrade InfiniServ Software
7) Configure IPoIB IP Address
8) Build MPI Test Apps and Copy to Hosts
9) Reboot Hosts
a) Refresh ssh Known Hosts
b) Rebuild MPI Library and Tools
c) Run a command on all hosts
d) Copy a file to all hosts
e) View ibtest result files
P) Perform the selected actions
N) Select None
X) Return to Previous Menu (or ESC)
The submenus typically present operations in the typical order they would be used
during an installation. Pressing the keys corresponding to menu items (0-e in the
example above) will toggle the Skip/Perform selection for the given item. As shown
in the example above, more than 1 item may be selected. Once the desired set of
D000006-000 Rev A
3 – Getting Started
[Perform]
[Perform]
[ Skip ]
[Perform]
[ Skip ]
[Perform]
[Perform]
[Perform]
[Perform]
[Perform]
[Perform]
[ Skip ]
[ Skip ]
[ Skip ]
[ Skip ]
3-5