All_Analysis - Qlogic Fast Fabric User Manual

5 – Detailed Descriptions of Command LineTools
Health Check and Baselining Tools
5.6.7

all_analysis

(All):The all_analysis command has the following usage:
all_analysis [-b|-e] [-s] [-d dir] [-c file] [-t portsfile] [-p
ports] [-F chassisfile] [-H 'chassis'] [-G esmchassisfile] [-E
'esm chassis']
-b - baseline mode. The default is the compare/check mode.
-e - evaluate health only. The default is the compare/check mode.
-s - a save history of failures (i.e., errors and differences).
-d dir - a top-level directory for saving baseline and a history of failed
checks. The default is /var/opt/iba/analysis.
-c file - an error thresholds configuration file. The default is
/etc/sysconfig/iba/iba_mon.conf.
-t portsfile - a file with a list of local HCA ports used to access fabric(s)
for analysis. The default is /etc/sysconfig/iba/ports.
-p ports - a list of local HCA ports used to access fabric(s) for analysis.
The default is the first active port. This is specified as hca:port:
-F chassisfile - a file with a chassis in a cluster. The default is
/etc/sysconfig/iba/chassis.
-H chassis - a list of chassis to execute the command on.
-G esmchassisfile - file with the SM chassis in the cluster. The default
is /etc/sysconfig/iba/esm_chassis.
-H esmchassis - a list of SM chassis to analyze.
for example:
The all_analysis command will perform the set of analysis specified in
FF_ALL_ANALYSIS. This can be provided via the environment or via
fastfabric.conf. The set of analysis which can be specified are: fabric, chassis,
esm or hostsm. FF_ALL_ANALYSIS must be a space-separated list of the values
mentioned above. These correspond to the respective analysis commands
previously discussed.
5-86
0:0 = 1st active port in system
0:y = port y within system
x:0 = 1st active port on HCA x
x:y = HCA x, port y
all_analysis
all_analysis -p '1:1 1:2 2:1 2:2'
Q
D000006-000 Rev A