Windows Nt Driver Installation; Introduction; Windows Nt Driver Files; Windows Nt Installation - Qlogic SANblade 2300 Series User Manual

Windows NT Driver Installation

5.1

Introduction

This section provides instructions for installing the Windows NT driver under the
following operating system conditions:
Initial installation of the Windows NT 4.0 operating system and the
Windows NT driver
Installation of the Windows NT driver in an already installed Windows NT 4.0
operating system
Installing an updated Windows NT driver in an already installed
Windows NT 4.0 operating system that has an older version of the driver
5.2

Windows NT Driver Files

The latest version of the software drivers and documentation for Windows NT are
available on the QLogic Web site. Be sure to review the Readme.txt file for both
new and changed information.
5.3

Windows NT Installation

To install Windows NT 4.0 on a Fibre Channel hard disk attached to a QLA23xx
HBA, perform the installation procedures in
already loaded on your system, perform the installation procedures in
If Windows NT 4.0 and an older Windows NT driver are already installed on your
system, perform the update procedures in
FC2354601-00 A
Section 5
(QL2300.SYS)
section
section
5.3.1. If Windows NT 4.0 is
5.3.3.
section 5.3.2.
5-1