Extreme Networks e” series Hardware Installation Manual page 259

Figure 151: MSM before insertion in a BlackDiamond 6808
50015
CONSOLE
MODEM
MGMT
LINK /
ACTIVITY
PCMCIA
6 Extend the ejector/injector levers.
7 Install the module as follows:
a Slide the MSM into the appropriate lettered slot of the chassis, until it makes contact with the
backplane.
NOTE
Use the metal panel, not the PCB, to guide the MSM.
As the MSM begins to seat in the chassis, the ejector/injector levers begin to close.
b To close the ejector/injector levers, use both hands to push the levers toward the center of the
module. Apply equal pressure to each lever.
c To secure the module, tighten the two screws with a #1 Phillips screwdriver.
NOTE
Tighten the screws of this module before you insert additional modules. Otherwise, you might unseat
modules that you have not secured.
Extreme Networks Consolidated "e" and "i" Series Hardware Installation Guide
EW_clips
Installing MSMs
259