Extreme Networks e” series Hardware Installation Manual page 258

BlackDiamond 6800 Series Management Switch Fabric Module
CAUTION
You can install MSMs in lettered slots only. MSMs do not fit in numbered slots. Forceful insertion can
damage the MSM module.
3 Remove the blank faceplate from the slot to make room for the module, if necessary.
NOTE
Any unoccupied module slot in the chassis should have a blank faceplate installed to ensure
satisfactory protection from EMI and to guarantee adequate airflow through the chassis.
4 Hold the module by its front panel with one hand, and place your other hand under the edge of the
metal panel to support the weight of the module.
Check the connectors for dust and packing materials.
CAUTION
To prevent ESD damage, handle the module by the metal panel edges only. Never touch the
components on the PCB or pins on any of the connectors.
5 Position the module correctly for the switch into which you are installing it.
For the BlackDiamond 6816 or the BlackDiamond 6804:
• The MSM is horizontal as shown in Figure 150.
• The module name is to the left.
Figure 150: MSM before insertion in a BlackDiamond 6816 or a BlackDiamond 6804
For the BlackDiamond 6808:
• The MSM is vertical as shown in Figure 151.
• The module name is at the top.
258
EW_clips2
Extreme Networks Consolidated "e" and "i" Series Hardware Installation Guide