To Enable Dual Display Clone Mode - EUROCOM Notebook User Manual

Advanced Controls
3
Figure 3 - 8
Device Settings
(Clone Mode)
3 - 14 Display Devices

To Enable Dual Display Clone Mode:

1. Plug the monitor into the appropriate port.
2. Go to the Intel(R) 82852/82855 GM/GME Graphics Controller Properties
control panel (see "Intel Video Driver Controls" on page 3 -
Devices (tab).
3. Click the Intel(R) Dual Display Clone icon in the devices tab (Note: this
option is only available when you have attached the monitor).
4. Choose which device is to be the Primary display, and which is to be
Secondary.
5. Adjust the settings by clicking the Device Settings (button) if necessary.
6. Click Apply > OK and close the control panels.
8) and select