Switching/Enabling Displays (Driver) - EUROCOM Notebook User Manual

Advanced Controls
Vertical Refresh Rate
3
The vertical refresh rate
of your monitor is impor-
tant. If it is too low and/or
you're using fluorescent
lighting, the screen will
appear to flicker. To re-
duce flickering on a moni-
tor, use faster refresh
rates (we recommend a
refresh rate of 72Hz or
more). But first check
your monitor's documen-
tation to make sure it can
support the rates listed by
the video driver. The de-
fault refresh rate for mon-
itors (without drivers) is
60Hz.
Figure 3 - 7
Switching Display
Settings
3 - 12 Display Devices

Switching/Enabling Displays (Driver)

With the video driver installed (see pages
built-in controls to switch between the displays as follows:
1. Plug the monitor into the appropriate port.
2. Go to the Intel(R) 82852/82855 GM/GME Graphics Controller Properties
control panel (see "Intel Video Driver Controls" on page 3 -
Devices (tab).
3. Choose the display option from the list on the left and click Apply (and OK
to confirm the settings change).
4. You can choose a device to be Primary or Secondary.
See the following pages for instructions on enabling Clone and Extended
Desktop modes.
4 - 9 & 4 - 15), you can use its
8) and select