The Printer Stops During A Print Job; An Error Message Is Shown On The Display Screen; The Printer Ejects Blank, Unprinted Paper - Canon iPF655 - imagePROGRAF Color Inkjet Printer User Manual

The printer stops during a print job

The printer stops during a print job

An error message is shown on the Display Screen

An error message is displayed during printing.
The last portion of roll paper was used during a print
job, and paper could not be advanced because the
trailing edge is taped to the roll.

The printer ejects blank, unprinted paper

The leading edge of the roll paper was cut to
straighten it.
The Printhead nozzles are clogged.
A print job was received from an incompatible printer
driver.
The printer has received print data that includes HP
RTL commands when Auto Rotate is On in the
Control Panel menu.
The printer is damaged.
The printer stops when printing a HP-GL/2 job (the
carriage stops moving)
The printer is analyzing the print job.
A job was printed when Input Resolution in the
Control Panel menu was set to 600dpi.
730 Troubleshooting
Status
Status
Cause
Corrective Action
Check the error message and take action as
necessary.
(See "Error Messages.")
Remove the used roll and insert a new roll.
(→P.118)
(→P.120)
(→P.81)
Corrective Action
The leading edge of rolls may be cut to straighten
it if you have selected Trim Edge First > On or
Automatic in the Control Panel menu.
(→P.135)
Print a test pattern to check the nozzles and make
sure the Printhead is in good condition for printing.
(→P.692)
Use the correct imagePROGRAF printer driver for
the printer and try printing again.
In the Control Panel, set Auto Rotate to Off and
print again.
(→P.49)
Contact your Canon dealer for assistance.
Corrective Action
Please wait a while until printing is nished.
In the Control Panel menu, set Input Resolution to
300dpi and print again.
(→P.49)